Measuring the SmartFusion2 Core Current (VCC1V2 net) on SF2-STARTER-KIT Print

 

In order to measure the SmartFusion2 core current (VCC1V2 net) on the SF2-STARTER-KIT, do the following:

  1. Remove R46 on the M2S SOM.
  2. Depending on a used tool, do one of the following:

    • Using a voltmeter: Solder a current sense resistor on the R46 pads. Resistor value must be no higher than 0.1 Ohm. Connect the voltmeter to TP1 (+) and TP2 (-).
    • Using an amperemeter: Connect the amperemeter securily to the R46 pads or the test points TP1 (+) and TP2 (-).